Cylinder& Piston (Disassembly) - Husqvarna 50 Workshop Manual

12
Disassembly
Remove the cylinder cover and air filter. Clean around
the cylinder base to prevent dirt and debris from entering
the crankcase when the cylinder is removed.
Remove the carburetor and intake manifold as described
in section 10. Fuel System. Remove the spark plug and
the exhaust system.
Remove the four screws retaining the cylinder to the
crankcase with the 8 mm T-handle wrench P/N
5025022-01. Carefully lift the cylinder straight up off the
crankcase and piston.
Cover the crankcase opening with a clean cloth wrapped
around the connecting rod. Remove the piston pin
retaining clips and push the pin out. Separate the piston
from the connecting rod. Clean the carbon from the
piston crown.
Cylinder& Piston