Rapide - Klark Teknik HELIX Hardware Setup Manual

6.5

RapidE

The RapidE acts as an Ethernet network hub allowing you to connect a PC, console and HELIX units. It
gives you the option to control the console/HELIX units remotely without using the PC, if you wish.
To network the RapidE
Each connection to the RapidE must be via Ethernet cable, and any of the RapidE's eight external ports
can be used for any connection. Each external port connection that connects HELIX units is treated as a
single network.
Any combination of DN9340E,
DN9344E and DN9848E units. See
Sections 6.2 and 6.4 for available
connections, where the PC should be
replaced by the RapidE.
Note So that the networks can run on different protocols the PC needs to be running RCS programs
of equivalent protocol.
HELIX Remote Control: Hardware Set-up Guide
Any combination of DN9340, DN9344
and DN9848 units. See Sections 6.3
and 6.4 for available connections,
where the PC should be replaced by
the RapidE.
21
User Guide