Parts List - Honeywell F118 Product Data

Motor
The motor is visible when the filter frame is removed. Inspect
the motor brackets for loose fasteners; tighten as necessary.
Pre-filter
The disposable pre-filter collects large dust particles and lint-
type airborne fibers. It is wrapped around the particle filter and
held in place with two clips. Check the filter every two weeks.
To change the pre-filter:
1. Wrap a new pre-filter around the new particle filter.
2. Attach the two new clips to hold the pre-filter in place.
(New clips are supplied with pre-filter replacements.)
3. Position the filter frame in the air cleaner.
4. Pull down the spring-loaded support rods together, posi-
tion over the filters and secure in place.
CPZ Adsorbent Module
™
The CPZ™ adsorbent module is used to collect gases,
vapors, odors and volatile organic compounds (VOC) from the
air that passes through the air cleaner. The impurities are
collected until the adsorbents reach saturation, when a
continuously strong pungent odor is emitted. If the air cleaner
is turned off for eight to ten hours, a temporary odor is emitted
when it is turned back on. If the odor persists for 30 minutes, it
is time to replace the filters.
The useful life of the CPZ™ sorbent modules can vary from
four to 24 months, depending on the application. In most
applications, the sorbent media life ranges from 12 to 18
months. Change modules and filters more frequently in
facilities that operate 24 hours a day.

PARTS LIST

See Fig. 10
.
No.
1 CPZ™ sorbent module (2)—used only with DOP particle filters.
2 DOP primary particle filter, 95 percent (1).
3 Pre-filter (disposable) (1).
4 Blower wheel (1).
5 Motor assembly (1), 120V.
Motor assembly (1), 230V.
Motor mount.
6 Inlet cone (1).
7 Grille assembly, without hinges and latches (1).
8 3-speed switch.
9 Spring loaded plunger (2).
10 Motor maintenance grommet set (1)—(not illustrated).
11 Optional speed switch, variable (1)—(not illustrated).
( ) = Quantity required per unit.
NOTE: When tobacco smoke is a contaminant, both the par-
CAUTION
Eye Exposure.
Harmful dust can obstruct or injure unshielded
eyes.
CPZ modules normally release dust when handled.
Always wear safety glasses when installing or remov-
ing CPZ modules.
1. Tilt the module up from the inside cabinet lip.
2. Use both hands to lower the CPZ module down and out
from the end of the cabinet.
3. Place the used module in a plastic trash bag and dis-
pose of properly.
4. Unwrap new CPZ™ sorbent modules and install.
IMPORTANT
NOTE: Upon initial startup, a small amount of dust can blow
Description
9
F118 IN-CEILING MEDIA AIR CLEANER
ticle filter and the CPZ adsorbent filter must be ser-
viced at the same time.
Avoid excessive pressure on individual adsorbent
panels.
from the air cleaner. This is normal and stops a few
minutes after startup.
Pack Qty.
1
1
1
1
1
1
1
1
1
1
2
3
1
Order Number
32002271
32002272
32002590
32002269
32002587
32004512
32002589
32002286
32002266
00190382
32002278
32000261
32000234
68-0209-2 Revised 11-07