Honeywell F118 Product Data page 5

PLACE WIRE SUPPORTS AS CLOSE AS POSSIBLE
TO F118 SUPPORT SHOULDER POSITIONS,
APPROXIMATELY 5 IN. (127 MM) FROM ENDS.
1
1
SUSPENDED
CEILING
SUPPORT SHOULDER
POSITIONS
1 BE SURE TO TWIST THE SUPPORT WIRE A MIINIMUM
OF FOUR TIMES TO PROPERLY BEAR WEIGHT.
THERE MUST BE 12 IN. (305 MM) BETWEEN DROP
2
CEILING AND STRUCTURAL CEILING.
Mount Air Cleaner Cabinet
WARNING
Fire or Electric Shock Hazard.
Can cause personal injury or equipment damage.
Do not connect the power source until after electronic
air cleaner is mounted.
1. The cabinet has multiple slots. See Fig. 4. Insert the
support shoulders into the selected slots.
2. Bend the two tabs on each support shoulder until the
tabs are flush with the cabinet.
STRUCTURAL CEILING
2
F118
Fig. 4. Mounting procedure.
T-BAR/DROP CEILING SUPPORT SYSTEM
1
1
SUPPORT SHOULDER
LOCATIONS (8)
DROP
CEILING
3. Thread wire through the support shoulders. Make sure
the wire is strong enough to support the total weight of
the air cleaner. Never rest the air cleaner on the T-bar
unless it has been reinforced to hold the weight.
4. Twist the support wire a minimum of four times.
WARNING
Equipment Falling Hazard.
Can cause personal injury, structural weakening,
buckling, or damage to equipment.
Be sure platform is stable and can support combined
weight of installer and equipment.
Use assistant to help support equipment during instal-
lation.
5
F118 IN-CEILING MEDIA AIR CLEANER
24 IN.
24 IN.
(610 MM)
(610 MM)
24 IN.
(610 MM)
REMOVE
T-BAR TO CREATE
48 X 24 IN.
(1219 X 610 MM) SPACE.
BEND TABS TO
HOLD MOUNT
ON AIR CLEANER
SUPPORT
SHOULDER
(1 OF 8)
REINFORCED
T-BAR
M16212A
68-0209-2 Revised 11-07