(B) Installation Of Built-In Unit; (C) Reversing The Door Swing - N'Finity 273 03 70 Instruction Manual

(b) Installation of Built-In Cellar
The cutout dimension illustrated in figure ( B ) allows for door
when installed as a built-in appliance.
If installing between frameless cabinets, a ½" wide filler strip or side panel may be needed on hinge side.
The filler strip will act as a spacer between the appliance case and adjacent cabinet door swing.
.
(c) Reversing the Door Swing of Your Appliance
The unit is delivered to you with the door opening from the left side (hinges on the right).
The door of this appliance is capable of opening from either the left or right side. To reverse the door swing
of your cooler and open from the right side, please follow the instructions and diagram as follows:
Before you begin to reverse the door it is recommended to tape down shelves to avoid movement during
the process
It is recommended to place the Wine Cellar on it's side prior to reversing the door
Locate the extra set of hinges in the plastic bag containing the instruction manual
swing and access to the pull-out shelves
The cutout depth must be 27".
5
Figure B