Undersink Installation - Kenmore 625.38575 Owner's Manual

- STEP 5: INSTALL STORAGE TANK,
MAKE REMAINING TUBING CONNECTIONS -
1. CONNECT DRAIN TUBING, FAUCET TO
DRAIN ADAPTER: Referring to Figure 8, run the
loose section of black 3/8" tubing from the faucet to
the drain adapter, with a black collet, installed on
page 6. Cut this tubing as needed to route in as
straight of a run as possible, without loops, dips,
low spots or kinks. Cut the end of the tubing square.
Then push all the way into the fitting. Pull on the tub-
ing to be sure it's held firmly in the adapter fitting.
See page 14 for tubing connection instructions.
2. CONNECT TUBING TO WATER SUPPLY: Con-
nect the feed (green) tube to the water supply fitting
installed on page 5. Connection to the fitting is as
described in Figure 12, page 14.
3. Move the storage tank into place next to the RO as-
sembly. You can stand the tank upright, or lay it on
side. Apply no more than two wraps of Teflon tape
to the threads on the nipple at the top of the tank.
Hand tighten the other included tubing adapter fit-
ting with the yellow collet onto the tank nipple, then
wrench 1/4 turn only. BE CAREFUL NOT TO
CROSS THREAD.
4. Run the 3/8" yellow tubing to the fitting installed
in step 3. Be sure the end of the tubing is cut square,
and insert all the way into the fitting. Again, pull on
the tubing to be sure it's held firmly in the fitting.
water supply
fitting
HOT COLD
drain
adapter
sink p-trap
TYPICAL UNDERSINK INSTALLATION
TUBING
telephone
_&,, style cable
tubing adaptor yellow collet
Note: See note on page 4
regarding tubing lengths.
Figure 8
8
Problems, Questions? Call 1-800-426-9345 Kenmore Water Line