Table of Contents
Advertisement
Limit 380
Firepoint 360
Spirit 550
F R E E STA N D I N G
W O O D ST O V E S
INSTALLATION MANUAL
This manual includes instructions for the Installation,
Operation and Maintenance of your stove.
Please read this entire manual carefully before installing
Save these instructions for future use.
Always follow the instructions contained in the manual.
For more information go to: www.bosca.co.nz
Models:
Limit 380
Firepoint 360
Spirit 550
and lighting your stove.
Advertisement
Table of Contents
Related Manuals for Bosca Limit 380
Summary of Contents for Bosca Limit 380
- Page 1 Limit 380 Firepoint 360 Spirit 550 Please read this entire manual carefully before installing and lighting your stove. Save these instructions for future use. Always follow the instructions contained in the manual. Spirit 550 For more information go to: www.bosca.co.nz...
-
Page 2: Table Of Contents
How do I remove the ash from my stove? INSTALLATION How do I clean the glass panel on my stove? What is the most adequate loaction to install my Bosca stove CHIMNEY FIRE What is the correct way to install my bosca stove... -
Page 3: Principal Components
INSTALLATION MANUAL MAIN COMPONENTS WARNING: THIS APPLIANCE AND FLUE SYSTEM SHALL BE INSTALLED IN ACCORDANCE WITH AS/NZS 2918:2001 AND THE APPRO- PRIATE REQUIREMENTS OF THE RELEVANT BUILDING CODE OR CODES. Flue Spigot WARNING: APPLIANCES INSTALLED IN ACCORDANCE WITH THIS STANDARD SHALL COMPLY WITH THE REQUIREMENTS OF AS/NZS 4013:1999 WHERE REQUIRED BY THE REGULATORY AUTHORITY, I.E. -
Page 4: Introduction
For clearances to non-combustible or insulated walls refer to AS/NZS 2918:2001. Note: For Spirit 550 & Limit 380, side clearance (B) is to be no less than 200mm and rear clearance (A) no less than 100mm irrespective of wall material, to ensure access to rear of To ensure the safe and proper functioning of your stove, it must be installed according to the stove for baffle replacement. -
Page 5: Floor Protectors
If the wall behind the fire is a non-combustible ventilated surface as per AS/NZS 2918:2001 then clearances This can be achieved in the Limit 380 and Firepoint 360 by using the two holes provided in the can be reduced and the flue shield is not required. -
Page 6: What Is The Correct Way To Install My Bosca Stove
INSTRUCTIONS FOR REPLACING THE BAFFLE SPIRIT 550 LIMIT 380 4. To remove the baffle, 1. The Spirit model stove 1. The first stage hold it with both hands has a dismountable 11mm spanner 11mm spanner consists of removing the and slide it forward so that... - Page 7 INSTRUCTIONS FOR REPLACING THE BAFFLE SPIRIT 550 (continued) FIREPOINT 360 4. To remove the baffle, hold 1. The first stage consists 4. To remove the baffle, hold it with both hands and slide of removing the anchoring it with both hands and slide 11mm spanner it forward so that the bolts bolts of the baffle.
-
Page 8: Removing The Firebox Baffle
OPERATING INSTRUCTIONS How can I verify that the installation has been correctly executed? OPERATING INSTRUCTIONS We are aware of how important it is to feel confident that your stove has been properly installed. Therefore, if you wish to verify the installation, we recommend you use the following diagram to guide your inspection: How does the double combustion system work? Cowl Double combustion stoves have a secondary air inlet that preheats the air at a high temperature. -
Page 9: How Can I Recognize Dry Firewood Before Buying It
OPERATING INSTRUCTIONS 4. Light the fire and close the upper door of the stove. your efforts will have been wasted. This is why it is important that you safeguard the storage conditions. The wood must be stored in an isolated location so that it is not exposed to rain and 5. -
Page 10: How Do I Reload Firewood In The Stove
Logs must be loaded front to back as shown in the figure at right. As is the What maintenance does my Bosca stove require? case when lighting the fire, remember that it is better if the logs are arranged with spaces between them to allow air flow. -
Page 11: How Do I Clean The Flue On My Stove
IMPORTANT Bosca stoves contain a baffle that must be dismounted in order to clean the unit. 3. Remove the anchoring screws to dismount the baffle of your stove. We recommend you carefully read the instructions on removing the firebox baffle. -
Page 12: How Do I Remove The Ash From My Stove
How can I avoid a chimney fire? One of the main attractions of your Bosca fire is the visible fire. However, often this is limited because of spots that appear on the glass of the stove. To avoid this follow the instructions below: –... -
Page 13: Troubleshooting
Do not add more wood, make sure Your Bosca stove is identified by a serial number stamped on a plate on the inside of the ashtray the firebox is well closed door. No other Bosca stove of similar model has the same serial number. The serial number may and turn off the air be requested if you require a service. -
Page 14: Warranty
2.1.14 Where any incidental or consequential damage and act of God occurs. Subject to the exclusions in section 2 & 3, Escea undertake to put right any defects in the Bosca products supplied by Escea for the periods specified below:...