Kenmore 796.4031*9 series Use And Care Manual page 27

Front-loading automatic washer
Hide thumbs Also See for 796.4031*9 series:
Table of Contents

Advertisement

Available languages

Available languages

BEFORE
CALLING
FOR SERVICE
(cont.)
Door will not unlock when cycle is stopped or paused
Check if...
Then...
Interior temperature of washer is too high.
Water level in washer is too high.
Wash cycle time is longer than usual
Check if...
Then...
I
he washer automatically adjusts the washtime for the
amount of laundry, water pressure, water heating time and
other operating conditions.
The washer door has a safety feature to prevent burns.
For example, if the washer is paused during the hot wash portion of
a SANITIZE cycle, the interior temperature of the drum wilt be very
hot, so the door will not unlock. This is normal. Allow the washer to
coot until the DOOR LOCK indicator turns OFF on the display.
To drain the water, cycle the POWER OFF/ON, then press the SPIN
SPEED button without selecting a cycle.
This is normal. The washer adjusts cycle time automatically to
provide optimal results for the selected cycle. The time remaining
shown in the display is only an estimate. Actual time may vary.
Musty or mildewy odor in washer
Check if...
Incorrect or too much detergent has been used.
Inside of tub not cleaned properly.
Then,,,
Use only HE (High-Efficiency) detergent in accordance with the
manufacturer's instructions.
Run the CLEAN WASHER cycle regularly. Be sure to wipe around
and under the door seat frequently. See Care and Cleaning of the
Interior in Care and Cleaning on page 22.
Clean around door seat/glass to prevent odor or mildew:
1. Wipe dry the door seal/glass and the door opening area.
2. Wipe around the inner drum/door seal and the lower door seal.
3. For difficult-to-remove odors, use Affresh available at your local
Sears store or online at www.partsdirect.com.
I
Wrinkling
Check if...
Then...
Washer not unloaded promptly.
Always remove items from the washer as soon as the cycle is
complete.
Washer overloaded.
The washer can be fully loaded but the drum should not be tightly
packed, and the door should close easily.
Hot and cold water inlet hoses are reversed.
Hot water rinse can set wrinkles in garments. Check the inlet hose
connections.
ilii li
27

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

4031 - 4.2 cu. ft. front-load washer

Table of Contents