Control Panel Features - Kenmore 796.4031*9 series Use And Care Manual

WARNING:
To reduce the risk of fire, electric shock, or injury to persons, read and follow this
entire manual, including the Important Safety Instructions, before operating this washer.
CONTROL PANEL FEATURES
ii I
Vibration Guard
START/PAUSE
@ POWER (ON/OFF) BUTTON
Press to turn the washer ON. Press again to turn the
washer OFF.
NOTE: Pressing the POWER button during a cycle will
cancel that cycle and any load settings will be lost.
The door will unlock after a brief pause unless the
water level or temperature is too high.
g CYCLE SELECTOR KNOB
Turn this knob to select the desired cycle. Once the
desired cycle has been selected, the standard presets
will be shown in the display. These settings can be
adjusted using the cycle setting buttons anytime before
starting the cycle. (See the cycle guide on page 14 for
allowable settings. To protect your fabrics, not all
settings are allowed in all cycles.)
_ START/PAUSE BUTTON
_! CYCLE MODIFIER BUTTONS
Use these buttons to adjust the desired cycle options
for the selected cycle. The lights above the buttons
show the current selection. See page 19 for a complete
description.
NOTE : Not all settings are available on all cycle
selections. See chart on page 14 for details.
O SPECIAL CYCLE AND OPTION BUTTONS
These buttons are used to activate special cycles or
options. See page 20 for details.
O TIME AND STATUS DISPLAY
The display shows the estimated time remaining, cycle
status, and door lock status. See page 18 for a
complete description.
_ DISPENSER
Press this button to start the selected cycle.
If the washer is running, use this button to pause the cycle
without losing the current settings.
NOTE : If you do not press the START/PAUSE button
within 4 minutes of selecting a cycle, the washer
automatically turns OFF.
Dispenser drawer. This drawer contains the
compartments for detergent and additives. See
pages 16 -17 for complete information.
12