Robomow RM400 & Base Station Operating & Safety Manual page 44

Message
Displayed
Rain detected
- Robomow has skipped the last depart due to
Press GO rain detection
- The operation is delayed as Robomow
Rain detected detects rain on the scheduled time it should
start delayed start the automatic operation from the Base
Station.
Rain sensor
- Disconnection in the rain sensor wires.
disconnected
- The battery is fully charged (displayed when
Ready
charging through the standard power supply
keep charging
and not through the Base Station)
- The maximum operating time has been
Recharge battery reached (displayed in non-Base Station
zone)
Remove fuse - Robomow was lifted while the battery fuse is
before lifting connected.
- Some obstacle is stuck or wrapped around
the blade.
- Something is preventing a blade from
Remove fuse then rotating freely. Severe grass accumulation
check blade under the mowing deck; rope or similar
object wrapped around mowing blade.
- Object jammed under mower preventing
blade from rotating.
Replace blade - An automatic reminder to replace the blades
every 200 hours is displayed every 200 hours
- Robomow fails to enter the Base Station
Reposition base
during 'Base position' test
Splice wire
- Perimeter wire cut
(Confirm the Base
- Wire disconnected from the Base Station /
Station beeps
Perimeter Switch
continuously for cut
wire)
- An unknown fault has occurred and user
help is required
Start elsewhere
- Drive wheel motors have been working
under a severe load during automatic or
manual operation.
Probable Cause/Event
44
Corrective/User Action
- It is not recommended to cut wet or
damp grass, but if you choose to
override the rain sensor, change the
setting of the 'Rain sensor' to 'off' under
the ' Settings ' menu.
- Do not do anything; the message is
displayed until the Robomow will not
detect rain for x hours (as defined in the
' Delay after rain' menu).
- Press 'GO' to confirm
- Keep the charger (power supply)
connected and operating
- Connect the charger to the mower
- Remove the fuse before lifting
Robomow.
- CAUTION – Remove battery fuse
before lifting the mower.
- Inspect blades for foreign material or
debris preventing rotation.
- Clean out accumulated grass clippings
using a wooden stick.
- Replace the blades and restart the
counter of the blades replacement
reminder by choosing the 'Blades
replaced – Clear reminder' option
under the 'Settings' menu
- Reposition the Base Station; usually it
should be placed with the marked lines
on the Base aligned with the perimeter
wire. If the Base is placed in narrow
pass, where the distance from the
adjacent wire is less than 3 meters, the
Base Station should be placed in shift
of few cm towards out of the lawn.
- Confirm wire is plugged in and wire
leads are firmly attached.
- Walk along perimeter, including islands
and look for obvious cuts or break in
the wire. Repair with Robomow wire
splice connectors.
- In case the wire cut is not visible call
you service dealer for more information
how to find the wire cut.
- Manually drive/carry the mower away
from this particular area and restart
operation.
- Check to insure the mower is not stuck,
allowing the drive wheels to slip.
- Check the ground for holes or
indentions, where the mower has
stopped and fill it with dirt and level off.
- Check the drive wheels are free to
rotate and nothing block them.
- Remove the mower away from this
particular point and restart operation.