C. CONNECTDRAINHOSE
Proper
connection
of the drain
hose
will protect
your floors
from damage
due to water
leakage.
STEP 1. To prevent the drain hose from
coming off or leaking, it must be installed
per the following instructions:
IMPORTANT: To ensure proper installa-
tion, this procedure must be followed
exactly.
a. Wet the inside of the straight
end of
the drain hose with tap water. DO
NOT USE ANY OTHER
LUBRICANT.
b. Squeeze ears of silver, double-wire
clamp with pliers to open, Place clamp
over the straight end of the drain hose
1/4inch from the end.
AND
PUSH
1/4"
d. Place clamp
over area marked
"CLAMP."
Release
clamp.
c. Open
clamp.
Twist hose back and
forth while pushing
down onto drain
connector
at the bottom
of the washer.
Continue
until hose contacts
the
ribbed
stop on the cabinet.
1/4"
If you have:
You will need to buy:
Drain
hose that is too short
Drain hose,
Part No. 388423
and
hose kit, Part No. 285442
Drain
hose that is too long
Hose kit, Part No. 285442
A problem
with lint clogging your drain
Drain protector,
Part No. 367031
Parts listed are available from your local Sears store or Sears Service Center.
Call 1-800-366-PART
(1-800-366-7278).
14