Setting Your Cycle Selector Control; Permanent Press; Prewash; Soak - Kenmore 110.29882890 Owner's Manual And Installation Instructions

SETTING YOUR CYCLE
SELECTOR (TIMER)
CONTROL
Use this control to choose the agitation
time and to start the washer.
• For heavy soil and sturdy fabrics,
use the full time (SUPER if indicated).
• For light soil and delicate fabrics,
use less time (SHORT if indicated).
PERMANENT PRESS
The PERMANENT PRESS Cycle
includes a load cooling process
that reduces wrinkling compared
to other cycles.
You can select up to 10 minutes of
wash time.
NOTE: When the timer reaches PAUSE,
the washer will drain and pause for no
more than two minutes while some of
the wash water is drained and replaced
with rinse water.
ULTRA CLEAN or NORMAL
Use this cycle for most loads to get
between 4 and 14 minutes of wash time.
PREWASH
Use this cycle to get up to 4 minutes
of agitation to help remove heavy soils
and stains that need pretreatment.
PREWASH Cycle should be followed
by an ULTRA CLEAN, NORMAL, or
PERMANENT PRESS Cycle with
additional detergent.
RINSE
SHORT
,ULTRA CLEAN
SUPER -- 14
OFF
SOAK
SOAK Cycle features 4 minutes of
agitation followed by an unlimited soak
time to help remove heavy soils and
stains that need pretreatment. You will
need to reset the washer to a SPIN
setting to remove water. SOAK Cycle
should be followed by an ULTRA CLEAN,
NORMAL, PERMANENT PRESS or
PREWASH Cycle with additional detergent.
NOTE: We do not recommend hot water
for soaking. It may set some stains.
SPIN
OFF
2ND RINSE
SPIN
OFF
I°PERMANENT
PRESS
PREWASH
PUSH & TURN CLOCKWISE TO SET PULL TO START
'AUSE
PUSH TO STOP
*Some models have NORMAL Cycle.
24