Advertisement
PANEL CONTROLS
ALL LEFT AND RIGHT REFERENCES ACCURATE FROM REAR VIEW
INPUTS
Input 1:
High Sensitivity
Use this input for max pickup output and frequency response
Input 2:
Low Sensitivity (6dB)
Use this input for hotter pickups.
VOLUME
Controls overall gain/volume.Typically, breakup will begin to
occur around 3-4 on the dial. Higher setting may require less bass.
TREBLE
Controls high frequency response centered around 2Khz.
MID
Controls mid frequency response centered around 500hz.
BASS
Controls low frequency response centered around 60hz.
REVERB
Controls the amount of reverberation effect.
The drive and recovery circuits have been optimized for a
smooth reverb decay.
SELECTOR SWITCH
Off: Bypasses the vibrato circuitry.
Mono: Effect appears in phase at each speaker.
Stereo: Effect applied out of phase at each speaker.
Wet/Dry: Left speaker is affected,
Right speaker is unaffected.
Dry/Wet: Inverts the above in the speakers.
(VIEW FROM REAR OF AMPLIFIER)
.
INTENSITY
Controls the amount of modulation effect.
A good balance of effect should be maintained for normal use.
FM/AM SWITCH
Controls whether the effect is exclusive Magnatone pitch
shifting vibrato (FM) or conventional tremolo (AM).
AM
- Amplitude Modulation
FM
- Frequency Modulation
REMOTE PEDAL
Connect the optional Magnatone remote pedal here.
Use any 1/4" mono or stereo guitar cable. When connected,
the front panel speed control is disabled. The remote pedal
works with both FM and AM settings
SPEED
Controls the rate or speed of the selected effect.
The exclusive Magnatone design allows for extremly slow
"choral" settings not attainable from the orginal design.
When the remote pedal is connected, the front panel
control is inactive.
REMOTE SPEAKERS
Connect external speakers here. 8 Ohm minmum impedance.
LINE OUT
Line level outputs. Speaker response compensated for DI use.
Always maintain a speaker load while using the line output.
STANDBY SWITCH
Allow the amplifier 1 minute to warm up before engaging.
POWER SWITCH
Turns the amplifier on and off.
Make sure you are plugged into a proper grounded outlet.
.
Advertisement
