Advertisement
PANEL CONTROLS
INPUT
Connect your instrument here.
Use a high quality shielded cable.
GAIN SELECT
Selects between LO and HI gain modes. LO gain is for classic
clean tones with a slight crunch. HI gain mode adds a
cascaded tube for the ultimate chewy overdrive sound.
GAIN SELECT INDICATOR
Lights up when HI gain is selected.
GAIN
Controls overall gain/volume. Typically, breakup will begin to
occur around 3-4 on the dial. Each mode has a bright
capacitor for clarity and focus at lower settings.
TREBLE
Adjusts the high frequency response centered at 2 kHz.
BASS
Adjusts the bass response centered at 60 Hz. There is a "secret"
MID scoop that occurs when the Bass is on "10". This feature
allows for additional tonal variety.
MASTER
Controls the overall volume of the amplifier. Power tube
saturation begins around 6-7 on the dial.
FX SND
Use this jack to connect to your pedal input.
FX RTN
Connect your pedal output to this jack. Always use high quality
shielded cables.
STANDBY SWITCH
Allow the amplifier 1 minute to warm up before engaging.
POWER SWITCH
Turns the amplifier on and o . Make sure you are plugged
into a proper grounded outlet.
Advertisement
