Kohler SNOWPRO WH208 Service Manual page 7

2. Remove the hex nut, and remove the muffler. See
Figure 19.
Hex Flange Nut
Figure 19. Remove Hex Flange Nut.
3. Remove the exhaust gasket from the outlet.
Remove Engine Control Assembly
1. Disconnect the governor spring from the control
lever spring arm. See Figure 20.
Hex Flange
Screws
Governor Spring
Figure 20. Remove Hex Flange Screws.
2. Remove the hex flange screws, and remove the
control assembly. See Figures 20 and 21.
Control Assembly
Figure 21. Remove Hex Flange Screws.
NOTE: Reverse the previous steps to reassemble the
engine, referring to the torque specifications
on Page 11.
NOTE: If further disassembly of the engine is
needed, reference the CH270 service manual
for more information.
Engine Control Lever Assembly
1. Assemble the control lever assembly as follows:
flat washer, nylon washer, control lever, spring
washer, control lever washer, with the locking
hex flange nut torqued such that it requires
6 ±1 lb. (2.72 ±0.45 kg) to move the control lever
at location A. See Figure 22.
NOTE: The spring washer shape should cup towards
the control lever washer.
Nylon Washer
Control
Lever
Washer
Spring Washer
Hex Flange Lock Nut
Figure 22. Engine Control Lever.
NOTE: A spring scale or hanging weight are the
preferred method to apply the required load
force. If these are not available, adjust the nut
so it has adequate resistance to keep the lever
in place.
Hex Flange
Screws
Flat Washer
Location A
Control Lever
7