Kohler SNOWPRO WH208 Service Manual page 4

Perform the following steps to remove the
engine cover, electric starter, fuel tank,
and the engine control assembly.
Remove Control Knobs
Choke
1. Pull the choke control knob out. Pry the linkage
out from underneath the knob and lift the knob
off the linkage and remove from the engine cover.
See Figure 4.
Choke
Control
Knob
Figure 4. Remove Choke Knob.
Throttle
1. Pull the control lever knob off the control lever.
See Figure 5.
Stop/Run Key
Figure 5. Remove Key and Control Lever Knob.
Stop/Run Key
1. Pull out the stop/run key. See Figure 5.
Remove Retractable Starter Cover
1. Remove the Torx screws securing the retractable
starter cover, and remove the cover. See Figure 6.
4
Linkage
Control Lever
Knob
Torx Screws
Figure 6. Remove Cover Torx Screws.
Remove Air Box Cover
1. Remove the hex flange nuts from the air box
cover and remove the cover. See Figure 7.
Figure 7. Remove Cover.
Remove Engine Cover
1. Remove the hex flange shoulder screws retaining
the engine cover to the blower housing. See
Figure 8.
Shoulder Screws
Figure 8. Remove Shoulder Screws.
Hex Flange Nuts