Kohler SNOWPRO WH208 Service Manual page 5

2. Remove the Torx screws securing the engine
cover. See Figure 9.
Torx Screws
Figure 9. Remove Torx Screws.
3. Do not fully remove the cover from the engine.
The primer hose and the key switch wires are still
attached at this time.
Disconnect Primer Assembly Hose
1. Pull the hose off the back of the primer assembly.
See Figure 10.
Stop/Run
Key Switch
Wires
Figure 10. Remove Hose and Wires.
Disconnect Key Switch Wires
1. Remove the stop/run key switch wires from the
back of the engine cover. See Figure 10.
2. The engine cover can now be set aside.
Remove Air Box
1. Remove one hex flange screw and two hex
nuts securing the air box to the carburetor, and
remove the air box from the studs. See Figures 11
and 12.
Figure 11. Remove Air Box Screw.
Figure 12. Remove Air Box Hex Nuts.
Remove Electric Starter (If Equipped)
Primer Hose
1. Remove the hex flange screws securing the
Figure 13. Remove Electric Starter.
Hex Nuts
electric starter to the crankcase, and remove the
electric starter. See Figure 13.
Hex Flange
Screws
Hex Flange
Screws
5