HHB CDR-850 Service Manual page 82

CDR-850
70; Auto sequence 50 truck forward jump.
71; Auto sequence 50 truck reverse jump.
72; High-speed scanning mode which uses auto se-
quence 50 truck forward jump.
73; High-speed scanning mode which uses auto se-
quence 50 truck reverse jump.
74; The number of jumps in forward DTRNUM by com-
bining auto sequence 2N truck jump.
75; The number of jumps in reverse DTRNUM by com-
bining auto sequence 2N truck jump.
76; REC mode continuance processing after power
failure returns.
78; Search at blank.
79; Return mode when "Picup jump" and "Coming off
by focus" are generated in REC.
Error where mechanism contoller is generated.
91; Loading error.
C7; Not REC/PAUSE of Power CALIBRATION though
60 seconds passed.
d0; This product stops for NG or the ST0P key input in
Redum.
d4; Data has not become complete by TOC and PMA
lead.
d7; RF check NG at REC/PAUSE.
db; PMA/REC will not end in 60 seconds.
dd; This product stops for the TOC check error or the
STOP key input.
d f; Not REC/PAUSE in 60 seconds, The REC begin-
ning cannot be done in ten seconds.
The return after Picup jump will not end in 60 sec-
onds.
F0; mechanism contoller communication error.
F1; mechanism contoller hardware error : In this case,
the NG pin number of mechanism contoller is dis-
played in TRACK.
F2; mechanism contoller A/D input (RFT,RFB) error.
F5; Serial Namber error forRID.
Two digits displayed in 3 : Recording sub-mode when error
10: REC/PAUSE is being set.
20: REC/PAUSE is being.
30: REC is being.
40: REC stop is being.
50: Unlock and SCMS is stopping.
Two digits displayed in 4 : Other states when the error generation
is done are displayed by the HEX code.
bit7: Focus coming off.
bit6: Synchronization coming off is detected at REC.
bit5: Picup jump detection at REC.
bit4: TOC lead error (Data does not become complete).
bit3: The A/D value is abnormal of RFT and RFB.
bit2: There is no meaning.
bit1: There is no meaning.
bit0: There is no meaning.
82
generation is done.