Installing Or Removing The Blade - Makita XBP01 Instruction Manual

Release the switch trigger to stop. After use, always
press in the trigger-lock button from A side.
Lighting up the lamp
CAUTION:
Do not look in the light or see the source of light
•
directly.
1
014188
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
The lamp goes out just after releasing the trigger.
NOTICE:
Do not apply impact to the lamp, which may cause
•
damage or shorted service time to it.
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it
may lower the illumination.
Do not use thinner or gasoline to clean the lamp.
•
Such solvents may damage it.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.

Installing or removing the blade

CAUTION:
Oil on the blade can cause the blade to slip or
•
come off unexpectedly. Wipe off all excess oil with
a cloth before installing the blade.
Always wear protective gloves when handling the
•
blade.
Use caution when handling the blade to avoid cut
•
by the sharp edge of the blade teeth.
Keep your body away from the blade area when
•
checking the blade movement.
When turning the blade tightening lever clockwise
•
to release the tension on the blade, point the tool
downward because the blade may come off
unexpectedly.
1. Lamp
1
2
014189
To install the blade:
1. Turn the blade tightening lever clockwise until it
stops to loosen the wheel.
2. Match the direction of the arrows on the blade
and on the wheels.
2
014190
1
014236
3. Insert the non-serrated side of the blade into the
upper holder and lower holder. Make sure the
blade in both upper and lower holder touches to
the bottom bearings.
1
A
014191
4. With pressing the middle part of the blade,
position the blade around one wheel. Moving the
wheel to A side makes it easier to do so.
5. Position the blade on another wheel similarly.
6
1. Tighten
3
2. Loosen
3. Lever
1. Lower holder
1
2. Upper holder
1. Bottom bearing
1. Wheel