Desa CCL3924NR Owner's Operation And Installation Manual page 22

MANUAL LIGHTING
PROCEDURE
1. Follow steps 1 through 6 under Lighting
Instructions, page 21.
2. Press control knob and light pilot with
match.
3. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob. Now follow steps 9
Lighting Instructions, page 21.
OPTIONAL HAND-HELD
REMOTE OPERATION
Note: Hand-held remote control accessories
must be purchased separately (see Acces-
sories, page 34). Follow instructions included
with the remote control.
NOTICE: you must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions on page 21.
After lighting, let pilot flame burn for about
one minute. Turn control knob to ON position.
Adjust flame adjustment knob anywhere be-
tween HI and LO. Slide the selector switch to
the REMOTE position (see Figure 32).
Note: The burner may light if hand-held re-
mote was on when selector switch was last
turned off. You can now turn the burner on and
off with the hand-held remote control unit.
IMPORTANT: Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
Flame Adjustment
Knob
Selector Switch in Remote Position
Figure 32 - Setting the Selector Switch,
Control Knob and Flame Adjustment
Knob for Remote Operation
22
OPERATION
Control
Knob
ON
OFF
REMOTE
www.desatech.com
Continued
ON/OFF SERIES (MODEL HRC101)
Hold the control button on the hand-held
remote until burner turns on. Hold the con-
trol button again until burner turns off (see
Figure 33).
To Lock press both buttons on hand-held
remote control until light stops flashing. Hand-
held remote control is now locked. If the fire
is on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
To Unlock press both buttons together
on hand-held remote control until the light
stops flashing. The hand-held remote is now
unlocked.
Indicator
Light
Figure 33 - On/Off Hand-Held Remote
Control Unit (HRC101)
THERMOSTAT SERIES (MODEL
HRC201)
The hand-held remote can be operated using
either the manual mode (MANU) or thermo-
static mode (AUTO) (see Figure 34). To select
Fahrenheit/Centigrade mode display, carefully
press the ˚C/˚F mode button with the end of a
paper clip or similar blunt object.
Locks
System to
Prevent
Accidental
Ignition
Turns
Burners
On or Off
Increases or
Decreases
Room
Temperature in
AUTO Mode
Figure 34 - Thermostat Hand-Held
Remote Control Unit (HRC201)
Digital
Display
Shows
AUTO
ROOM SET
Temperature
TEMP TEMP
and Settings
TEMP
LOCK
POWER
Turns Hand-
Held Remote
On or Off and
MANU AUTO
ºC/ºF
Allows You
to Choose
the Manual
Setting
Selects
°C/°F Mode
AUTO Mode
Button
Control
Button
111161-01K