Desa CCL3924NR Owner's Operation And Installation Manual page 18

INSTALLING LOGS
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
CAUTION: After installa-
tion and periodically thereafter,
check to ensure that no flame
comes in contact with any log.
With the heater set to Hi, check
to see if flames contact any log. If
so, reposition logs according to
the log installation instructions
in this manual. Flames contact-
ing logs will create soot.
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install these
logs exactly as instructed. Do not modify logs.
Only use logs supplied with heater.
1. Place front log (#1) on grate fingers. Make
sure front log rests firmly between grate
fingers and grate base (see Figure 23).
2. Place base of middle log (#2) in the U-
shaped slots of grate base. The cutout on
the right of middle log should fit over the
burner (see Figure 24). Make sure front
of middle log is resting on tabs of grate
base.
3. Locate pegs on bottom of back log (#3).
Slide pegs into holes in grate base behind
burner (see Figure 25).
18
INSTALLATION
Continued
Figure 23 - Installing Front Log (#1)
Figure 24 - Installing Middle Log (#2)
Figure 25 - Installing Rear Log (#3)
www.desatech.com
Grate
Fingers
Grate
Base
(CCL3930PR/NR Shown)
Middle Log (#2)
Tab
(CCL3930PR/NR Shown)
Hole in
Grate
Base
(CCL3930PR/NR Shown)
Front Log
(#1)
Burner
U-Shaped
Slot
Pegs
Burner
111161-01K