Desa CCL3924NR Owner's Operation And Installation Manual page 17

4. Install remote receiver unit onto gas log
heater base using Phillips head screws
(see Figure 19).
5. Connect wires as shown in Figure 20.
Front
Screws
Remote
Receiver
Figure 19 - Installing Remote Receiver
White Wire From
Receiver
Red Wire
From
Receiver
Figure 20 - Connecting Wires
INSTALLING WIRELESS HAND-
HELD REMOTE CONTROL
ACCESSORY
Two 9-volt alkaline batteries (not included)
are required to operate this heater with the
wireless hand-held remote control set. One
battery must be installed in the receiver and
one in the hand-held remote control unit.
Note: Only use alkaline batteries.
111161-01K
INSTALLATION
Continued
Installing 9-Volt Battery in Receiver
1. Locate back of receiver under front burner
of heater.
2. Locate battery clip mounted on back of
receiver.
3. Slide a 9-volt battery through clip.
4. Attach terminal wires to battery.
Back
Receiver
9-Volt
Battery
Figure 21 - Installing Receiver on Back
Installing 9-Volt Battery (Not Included) in
Hand-Held Remote Control Unit
1. Remove battery cover on back of remote
control unit.
2. Attach terminal wires to battery. Place
Valve
battery into battery housing.
3. Replace battery cover onto remote control
unit.
Terminal
Wires
Figure 22 - Installing Battery in Hand-
www.desatech.com
Battery
Clip
of Base
Battery
Cover
9-Volt
Battery
Held Remote Control Unit
Terminal
Wires
Remote
Control Unit
Battery
Housing
17