What You Need; Procedure - Part 1 (Basic Installation) - Panasonic KX-TVP50 Getting Started

The components you need are shown in FIG.1 (on page 12). The DPT is required to program the
PBX. To set the DIP switch, you will need something long, sharp, and hard (such as a straightened
out paper clip or a pen).
You should also have the Installation Manual and Operating Instructions (User Manual) for the PBX.
It is expected that you know how to program the PBX from the DPT.
The manual you are holding covers basic installation with the Panasonic KX-TD series PBX.
Please decide if you want AA Service or VM Service. Your selection will be needed in Procedure -
Part 1. In Procedure - Part 3 you will learn how to change greetings (voice prompts).
Procedure – Part 1 (basic installation)
In this part, you will (I) prepare the PBX, (II) set up a mailbox for each subscriber of the VPS, and
(III) select System/User 1/User 2 Prompts.
To begin with, both the VPS and PBX must not be powered. Their power LEDs should be off.
(I) Prepare the PBX
Connect PORT 1 of the VPS to JACK 02 of the PBX with 4-conductor
1.
cable.
Please see FIG.1 (on page 12).
Connect an DPT to JACK 01 and turn on the PBX.
2.
Confirm that the time and date are correct — this is important because this information will be
transmitted to the VPS at a later stage.
If the time and date are not correct, make corrections with System Program [000] "Date and
Time Setting".
change the PBX extension numbering plan, change it now
3. If you want to
with System Program [003]
JACK 01=Extn.201
JACK 04=Extn.204
...etc...
However, you can change these assignments to fit your needs.
For example, JACK 01 can be set to Extn.401 if you like.
4. From the DPT of JACK 01, use System Program "Voice Mail Number Assignment", [126] (or
[117]) depending on the country model of your PBX, to enable DPT integration on JACK 02 of
the PBX. Follow the instructions in the PBX Installation Manual. If you cannot successfully
complete this programming step, you need to call for help.
Exit System Programming.
5.
"Extension Number Assignment". For example,
JACK 02=Extn.202
JACK 05=Extn.205

What You Need

JACK 03=Extn.203
JACK 06=Extn.206
Getting Started
5