Iii) Select System/User 1/User 2 Prompts - Panasonic KX-TVP50 Getting Started

Procedure - Part 1 (basic installation)
(II) Set up a mailbox for each subscriber of the VPS
1. If you want to
switch in position 2
(described on page 4),
. Power on the VPS
2
3. This completes the creation of a mailbox for each extension.
. Restore the DIP switch to position 0
4
Check the system:
5.
JACK 02).
You should hear:
If you do not hear this, something is wrong. Try again from (II) Step 1.

(III) Select System/User 1/User 2 Prompts

Please see Procedure – Part 3 (Step 3)
1.
prompts and decide what prompts you want to use. Then follow the steps below.
Power off the VPS.
2.
3. If you want to
(see FIG.2).
If you want to
(see FIG.2).
If you want to
(see FIG.2).
Power on the VPS
4.
Restore the DIP switch to position 0
5.
The prompts you want will be activated
6.
7. This completes "basic installation". Proceed to Procedure – Part 2.
Tip: If you want the maximum possible amount of memory for recording for callers and subscribers,
then erase User 1 and User 2 Prompts and select System Prompts. Otherwise, it is not
recommended that you use System Prompts. With System Prompts, you cannot selectively
record prompts as you like. When you use User 1 or User 2 Prompts, you have much more
flexibility, because you can modify any prompt you like. The Message Manager can easily
modify any prompt. This procedure is described in Procedure - Part 3.
6
Getting Started
set all VPS ports for AA Service
(see FIG.2). If you want to
put the DIP switch in position 3
and wait about 3.5 min.
Pick up the extension of JACK 01 and call the VPS (the extension of
You have zero new messages.
To receive the message, press 1.
To deliver a message, press 2.
To check the mailbox distribution, press 3.
For automated attendant status, press 4.
For mailbox management, press 5.
For other features, press 6.
To end this call, press .
use System Prompts, set the DIP switch to position 12
use User 1 Prompts, set the DIP switch to position 13
use User 2 Prompts, set the DIP switch to position 14
and wait about 3.5 min.
(described on page 4),
set all VPS ports for VM Service
(see FIG.2).
(see FIG.2).
for a brief explanation of VPS voice
(see FIG.2).
.
Confirm this by calling the system.
put the DIP