LG LDF9810ST Service Manual page 55

Appendix. C
※ If it is necessary to retrofit an earlier model with the new drying system,
please follow the instructions below for modifying or replacing parts.
1) Remove front door panel & control panel.
2) Remove old blower & vent.
3) Cut the door liner white felt pad as shown*. Scissors work best for cutting the
felt. (See Appendix C for part number if felt is to be replaced.)
*NOTE:
The w hite felt can be marked w ith a felt pen using the new v ent as a template.
4) Assemble and m ount the new blower & vent.
5) The control panel frame must be modified or replaced. If it is to be modified for
blower clearance, cut out areas shown in the
door liner prior to assembly to make sure panel does not touch blower motor
or housing as this could cause
*NOTE:
It is not recommended to modify the semi- control panel or front door panel. Retrofit of
the new drying system to LDS5811xx models s
door panel and control panel. ( see Appendix C for parts)
FRONT VIEW
Cut line
Cut out areas as shown
for blower clearance
(LDF9810xx shown)
photos below*. Test fit panel to
excess noise.
hould only be done by replacing the front
- 54 -
Discard
REAR VIEW