Kenmore 2318589 Use & Care Manual page 12

The Water Dispenser
IMPORTANT: Dispense enough water every week to maintain a
fresh supply.
To Dispense Water (Standard):
1. Press a sturdy glass against the water dispenser pad OR
place the glass below the water dispenser and press the
WATER button.
NOTE: While dispensing water and for 5 seconds after
dispensing has stopped, the digital display will show how
much water has been dispensed. The default unit is ounces.
To switch to cups or liters, press the UNITS button before
dispensing.
2. Remove the glass OR release the button to stop dispensing.
To Dispense Water (Measured Fill}:
Measured Fill allows you to dispense a specified amount of water
with the touch of a few buttons.
NOTE: The exact amount of water you select will be dispensed.
Be sure that the container is empty and can hold the entire
volume. If ice is in the container, you may need to adjust your
selection.
1. Press MEASURED FILL until the light turns on. Press
MEASURED FILL again to turn the feature off.
Measured Fill
A. Measured fill
B. Arrows
3=
4.
5=
Press the up and down arrows to adjust the volume as
desired.
NOTE: Most coffee cups (commonly 4 to 6 oz [118 to
177 mL] per cup) are not the same size as a measuring cup
(8 oz [237 mL]). You may need to adjust the volume to avoid
unintentionally overfilling coffee cups.
To dispense water, press a sturdy glass against the water
dispenser pad OR place the glass below the water dispenser
and press the WATER button.
0
NOTE: While dispensing water, the digital display will count
down how much water remains to be dispensed, according
to the volume you selected. The flow of water will
automatically stop once the desired volume has been
dispensed.
To stop dispensing before the selected volume has been
dispensed, remove the glass from the dispenser pad OR
press the WATER button a second time.
NOTE: If you stop dispensing before the desired volume has
been dispensed, the digital display will continue to show how
much water remains to be dispensed. The display will turn off
after one minute of inactivity.
To select a new volume or select the same volume again, you
must first finish dispensing the selected volume, or turn the
Measured Fill feature off and then turn it back on.
Rotating Faucet and Pull-out Tray (on some models)
Your dispenser may include a rotating water faucet and a small
pull-out tray at the bottom of the dispenser.
2.
NOTE: The dispenser will automatically turn off Measured Fill
after one minute of inactivity. When Measured Fill is turned
off, any changes you have made will be lost and all defaults
will be restored.
You can dispense water by the ounce, cup, or liter. The
default unit is ounces. To switch to cups or liters, press the
UNITS button.
Units
®
Default, minimum, and maximum volumes are listed below.
Units Default Minimum Maximum
Ounces 8 2 128
Cups 1 1/4 16
Liters 0.25 0.05 4
A. Faucet rotated 90 °
B. Pull-out tray
The faucet rotates up to 90 ° to allow for easy dispensing into
large containers. To rotate it, push in and release the left-hand
side of the faucet as shown.
The faucet rotates 90 ° automatically. However, you must
rotate it back into place manually. When in place, it will click.
NOTE: When using the dispenser with the faucet rotated, do
not use the water dispenser pad. Only use the WATER button
to dispense. Dispensing by pressing the container against the
water dispenser pad may result in unintentional spilling.
12