Table of Contents
Advertisement
ST5660A Installation Guide, Rev. B
High-level formatting
High-level formatting verifies the information written by the low-
level format and builds the file allocation table (FAT) used by DOS
to access files on the drive. Consult your MS-DOS manual to
learn how to use the DOS FORMAT utility to high-level format the
drive.
In Unix, high-level formatting creates the i-node used for file
access information. Drive formatting and partitioning are both
performed by a single operating system utility. Refer to your Unix
operating system documentation for instructions.
Troubleshooting
In the event of problems, you should perform the following basic
checks, which can resolve common installation difficulties.
Warning. Always turn your computer off before changing jump-
ers or unplugging cables and cards.
• Verify compatibility. Verify that the host adapter and the
drive are appropriately matched to each other and to your
computer. Refer to relevant documentation for details.
• Verify equipment configuration. Using the instructions in
the drive and host adapter installation guides, make sure that
all appropriate jumpers are installed, or removed, as needed.
• Check the power supply specifications. If new devices are
installed, your computer's power supply may not support new
total power requirements. When in doubt, consult your dealer.
• Check all cards. Verify that all cards are seated in their slots
on the motherboard and are secured with mounting screws.
11
Advertisement
Table of Contents
