Sym Fiddle 50 Service Manual page 118

Remove handle holder bolt plug.
Remove handle holder 4 bolts, then remove
handle holder.
Remove handle and front brake lever bracket.
Installation
Install handle and align with bolt hole.
Install bolt and then tighten it.
Torque value: 1.8~2.5kgf-m
Apply with grease onto throttle cable and the
sliding surface of handle.
Align the lock pin of the handle outer tube with
the hole on the handle, and then install the
handle.
Tighten the bolt.
Caution
Align the lock pin with the hole on the handle
and also install brake lever seat. Then,
tighten the lever with clamp and bolt.
Conduct following adjustment:
Oil pump control cable.
Throttle operation.
Brake lever free play
This chapter Contents
13. STEERING/FRONT WHEEL/SUSPENSION
bolts
bolts
13-5