Basic Usage Of P-Link Nano; Content Of The Package; System Requirements; Connecting P-Link Nano - Tele System P-Link Nano User Manual

P-Link Nano
NOTE
All P-Link Nano devices to be connected to your network must be connected to the same electrical
system. P-Link Nano automatically switch in stand-by mode when it cannot find another active device
in your network, such as a computer connected to its ethernet port. In stand-by mode the device
cannot be found via electrical system. Once a device (with ethernet interface) is connected to the
network, P-Link Nano automatically will come back to active mode and it can be reached via electrical
system.
5. Ethernet port(RJ45): insert here ethernet cable.

2.3 Basic usage of P-Link Nano

In this section the user can found all the necessary information for installing, using and configuring P-Link Nano.
Moreover you can find also the content of the package, minimum system requirements and main functionalities of
the device such as network protection.

2.3.1 Content of the package

Please check the content of the package before using P-Link Nano. The package consists in:
• 2 x P-Link Nano adapters;
• 2 x ethernet cables;
• 1 x quick start guide;
• 1 x warranty card.

2.3.2 System requirements

P-Link Nano does not have any particular requirement. It can work with any computer or device that has an operative
system with network support (that is a network card with ethernet port).

2.3.3 Connecting P-Link Nano

This section can help the user in connecting P-Link Nano to a computer (or other network device). In order to connect
P-Link Nano you need to follow the steps below:
1. Use the ethernet cable in the package in order to connect P-Link Nano to the ethernet port of your mo-
dem/router and plug the device to power socket.
2. Use the ethernet cable in the package in order to connect the second P-Link Nano to the ethernet port of your
PC (or network device) and plug P-Link Nano in a power socket.
NOTE
Please do not use multiple power sockets because they can interfere with data transmission. We
suggest to use wall socket in order to achieve the maximum allowed speed.
3. Once plugged in 2 P-Link Nano adapters (as described above), the network is fully configured and you can
start using it. In order to protect (encrypt) your network, please follow the procedure described in section 2.4.1.
4