Removing And Replacing The Warmer Drawer - Kenmore 790.7231 Series Use And Care Manual

Warmer Drawer
Removing and replacing the warmer drawer
Electrlcal shock hazard can occur and
result in serious injury or death. Disconnect appllance
from electrlc power before cleanlng and servicing the
warmer drawer.
Left-hand rail and release
To remove the warmer drawer:
1. Turn power OFF to the appliance before removing the
warmer drawer.
2. Open the warmer drawer completely.
3. On left warmer drawer rail, locate black release lever
and press up with finger while pulling out slightly on the
oven drawer handle. On right warmer drawer
rail,
locate black release lever and press down with finger
while pulling out slightly on the warmer drawer handle
(See Fig. 1).
4. The warmer drawer should now be released from the
rails. Remove warmer oven drawer (using level &
square motion) completely out and away from the
appliance.
To replace the warmer drawer:
1. Puii the bearing glides to the front of the outer
compartment glide channels until they snap into place
(See Fig. 3).
2. Carefully line up both sides of the warmer drawer glide
rails to the outer compartment glide channels located
inside the empty warmer drawer compartment (See
Fig. 2).
3. While holding the warmer drawer level and square
using the warmer drawer handle, push (do not force)
the warmer drawer all the way into the outer
compartment glide channels all the way into the range.
Open the warmer drawer again to verify the glides
have seated.
4. If you do not hear the levers "click" or the bearing
glides do not feel seated remove the warmer drawer
and repeat steps 1 through 3 again. This will minimize
possible damage to the bearing glides.
Warmer
drawer_
handle
Fig. 1
Fig. 2
Fig. 3
Right-hand rail and release
25