How To Prepare And Load Checks - Unisys My VisionX Operator's Manual

4.2 How to Prepare and Load Checks

Preparing Documents for Processing
1. Remove all rubber bands, staples, paper clips, dog ears, etc. from the documents.
2. Jogging the documents is strongly recommended. In any case, align the bottom edges by repeatedly
tapping the bottom edge of the documents on a hard, flat surface, see Fig.16.
3. Repeatedly tap the leading edge of the documents on a hard, flat surface, see Fig.17.
4. Check bottom and leading edges once more to ensure documents are aligned.
Bottom edge
Tip: Use a mechanical jogger device for faster and more accurate alignment of bottom and leading edges.
OPERATOR MANUAL
Fig.16
Page 22
Leading edge
Fig.17
Getting Started