Extension Plate Installation - Unisys My VisionX Operator's Manual

3.2 Extension Plate Installation

The feeder extension is designed to support all documents anticipated to be processed by the MyVisionX.
Markets or applications that process a large number of long documents (longer than 8 inches) may find it
necessary to apply the optional extension plate for better document support, reducing the risk of image
skewing, MICR rejects, etc. Assembly is made by sliding the extension plate, face side up, along the bottom
side of the feeder extension into the support notches until the plate snaps into place (Fig.8). The lock tabs
should securely fit into the round holes and the short and long tabs should be fully inserted into the
support notches (Fig.9).
Long and short tabs
Lock tabs should
Extension plate
should be fully inserted
Feeder extension
be in round holes
Fig.8 Fig.9
Face side up
into the support notches
Support notches
To remove, firmly grip the feeder extension and the extension plate and pull apart.
Page 15
OPERATOR MANUAL Operating your Unisys MyVision X