Power Cables Connection - Unisys My VisionX Operator's Manual

3.3 Power Cable Connection
Before connecting the scanner to your PC, make sure to locate the unit on a flat surface near the PC, away
from direct light and from electromagnetic equipment.
Warning: The electromagnetic emission from a CRT monitor can produce interference and affect the
MICR reading; therefore place the MyVision X as far as possible from the CRT.
1. Plug the power cord connector in the Power Supply socket (Fig.10).
2. Plug the Power Supply cable in the MyVision X power connector (Fig.11).
Fig.10
3. The MyVision X should be plugged into a dedicated electrical power outlet. The power supply will be
100-240 VAC (no power selection required), and the frequency 50/60 Hz. If you are not sure of the type
of power available, consult your Service Representative or local power company.
Note: There is no LED power indication upon connecting the MyVision X. LED status indicators only
illuminate when the application connects to the MyVision X unit. See section 4.1.
OPERATOR MANUAL
Fig.11
Page 16
Operating your Unisys MyVision X