Advertisement
English Version
Visit our website (www.zalman.co.kr) and watch the Reserator XT
installation video for an installation overview.
※ Please read this manual thoroughly before installation.
※ The specifications of this product and its components may change without
prior notice to improve performance.
1
•The specifications of this product and its components may change without prior notice to improve performance.
RESERATOR XT
RESERATOR XT
Installation and Operational Notes
Installation Notes
1. Do not place the unit in dusty or humid conditions, under direct sunlight, or near a heat
source such as a room heater.
2. Do not drop or subject the unit to excessive force.
3. Check the CPU socket compatibility before installation.
4. Do not mix any contaminants with the coolant when filling. It may cause product failure
or corrosion.
5. Place the unit on top of the PC or a location with good ventilation.
6. Check for leaks on the Water Blocks and Tubes before installation.
7. Preparing the necessary tools (Needle-Nose Pliers, Scissors) will ease the installation
process.
Operational Notes
1. Check to see if the DC cables are properly connected before use.
2. If the coolant is not circulating properly or if the
other reasons, then the red LED will begin to flicker with an alarm sound. Immediately
turn the PC OFF and contact the place of purchase.
3. Do not place any objects on the product.
4. Install the unit on a leveled surface free of vibration, and do not tilt or lay the unit on its
side while using.
5. Must use the provided coolant. Regularly check the amount of coolant and replenish
as needed (must be with new coolant every year).
6. If a leak is found, turn off the system immediately and contact the place of purchase.
7. Separate the Reserator from the PC case when moving the system.
8. Do not block the Air Ducts on either side of the product with any object. It could lead to
fan failure, increased noise, or a decrease in product performance.
9. Make sure that the Water Pump is functioning properly.
Disclaimer
Zalman Tech Co., Ltd. is not responsible for any damages due to external causes,
including but not limited to, improper use, problems with electrical power, accident,
neglect, alteration, repair, improper installation, or improper testing.
•The specifications of this product and its components may change without prior notice to improve performance.
pump' s flow rate becomes too low for
2
Advertisement
