ZyXEL Communications NBG-419N Installation Manual page 12

Hide thumbs Also See for NBG-419N:

Admin Password

SSID

Wireless Password

If you would like to reprogram your NBG-419N, you can do so by resetting it to factory

defaults. If you reset the NBG-419N, you lose all of the changes you have made. The NBG-

419N re-loads its default settings, and the password resets to 1234. You have to make all

of your changes again. Follow the steps below to RESET your router to factory defaults.

IMPORTANT: You will lose all of your changes when you push the RESET button.

To RESET the NBG-419N:

1. Make sure the power LED is on.

2. Press the RESET button for longer than one second to restart/reboot the NBG-419N.

3. Press the RESET button for longer than five seconds to set the NBG-419N back to its

factory-default configurations.

If the NBG-419N restarts automatically, wait for the NBG-419N to finish restarting, and

If the NBG-419N does not restart automatically, disconnect and reconnect the NBG-

419N's power. Then, follow the directions above again.

PO Box 190 2504 Ave. D. Wilson, KS 67490

Voice 800.432.7607

FAX 785.658.3344

Maintain This Information

Resetting the NBG-419N to Its Factory Defaults

Page 12 of 12

Table of Contents