Problem:
If the SADV 1245 R is connected to a
TV set directly using a SCART lead,
this can result in a scrolling DVD
picture appearing on all programme
memories. This problem may occur
with many types of TV.
Cause:
The TV set is analysing the A/V switching
signal from the DVD player incorrectly, or
not at all.
Remedy 1: If possible, call up the Setup menu for
your TV set and switch off RGB priority.
Select the RGB signal type for the DVD
SCART input of your TV set.
Remedy 2: If your television does not provide this
option, connect the DVD player using an
S-VHS lead, or use a SCART lead without
RGB signal. Ask your dealer for help
with this.
Remedy 3: When watching TV, switch off the DVD
player by pressing the
the front panel.
Problem:
When used in a non- system the
machine does not respond to remote
control
commands,
switched on by remote control.
Cause:
E 2000 remote control receiver not con-
nected.
Remedy:
Connect
the
receiver as shown in Wiring Diagram 3.
Press the source select button
(or
) on the remote control handset
to switch the machine on.
Problem:
When operating the menu for the surround
decoder
or
SADV 1245 R also responds.
Cause:
E 2000 connected to the SADV 1245 R.
Remedy:
Connect the E 2000 to the pre-amplifier,
integrated amplifier or receiver.
Problem:
MP3 CD does not play back.
Cause:
MP3 format not supported
(see 'Playing MP3 CDs').
Remedy:
(see 'Playing MP3 CDs')
Problem:
Distorted or double picture at the YUV
output
Cause:
P-Scan switched on buit TV set not
compatible with progressive video signals
Remedy:
Switch P-Scan off (
front panel).
button on
or
cannot
be
E 2000
remote
control
surround
receiver,
the
button on the
Problem:
No picture.
Cause:
Video-output switched off
Remedy:
switch ON the video output (
button on the front panel)
Problem:
Bad or distorted sound reproduction
Cause 1:
Multi channel mode is selected but only a
stereo amplifier is connected
Remedy:
switch
'Preference / Sound / Analog output'
Cause 2:
a multi channel amplifier is used but it is
switched to STEREO operation mode
Remedy:
switch the surround-amplifier to multi
channel mode
Problem:
'
overheat
overheat
overheat
overheat
Cause:
Device is over heated, too little flow of
cooling air
Remedy:
change the installation of your system to
provide sufficient cooling.
do not place the SADV 1245 R on top of
hot equipment like amplifiers or surround
receivers
Problem:
Not possible to switch to MCH mode
Cause:
Disc does not contain a multi channel
layer
Remedy:
no remedy, disc can only be played back
in Stereo.
Problem:
The 'WIDE'-mode can not be selected
Cause:
switch 'WIDE' at the back panel is set
position 'Disable'.
Remedy:
Set switch to position 'Enable'.
Problem:
Discs can not be played. A message to
enter a PIN appears.
Cause:
This disc is locked
Remedy:
Enter a valid PIN number or unlock the
disc (see menu 'Setup / Access').
Note:
In case you have forgotten your PIN
number, enter the menu 'Setup / Access /
Enter PIN'. Enter the input box on the
right and press the
times (the on screen display will show the
"forbidden" icon). Then enter 0000 twice.
The PIN is now reset to to 0000.
52
to
STEREO
in
the
' displayed, playback stopped
-button four
menu