Samsung SNB-6003 User Manual page 94

setup screen
External PTZ setup (SNB-6003/SNB-6004)
Configure the connection settings to the external pan/tilt receiver so that you can control
the PTZ operations via the receiver connected to the RS-485 port of the camera.
1. Select the <Video & Audio (
from Setup menu.
2. Click <External PTZ setup>.
3. Specify the serial port.
You can set the RS-485 communication
mode for pan/tilt-compliant receiver that
is connected to the network camera.
• Protocol : From SAMSUNG-T/
SAMSUNG-E / PELCO-D/PELCO-P
/ SUNGJIN / PANASONIC /
HONEYWELL / AD / VICON / GE /
BOSCH, select the same protocol as
that of the receiver.
• Camera ID : Displays the fixed
camera ID.
• Baudrate : Transfer rate for RS-485 communications.
• Data bit : Specify the data bit.
• Parity bit : Specify the parity bit.
• Stop bit : Specify the stop bit.
• ONVIF Focus move : Set external camera's focus for ONVIF controls. (It is
applicable only to the SNB-6004 model.)
4. When done, click [Apply (
All these operations above mentioned will be enabled only if the network camera is properly
M
`
connected to the pan/tilt-compliant receiver. And the serial port for the pan/tilt operations should
be properly specified.
Check the functions supported by the receiver when it is connected.
J
`
Some functions may be disabled depending on the receiver or protocol specification.
Refer to the following table for more details.
94_ setup screen
)> tab
)].