Advertisement
Ignitor Battery
Installation
- See Fig. 12
1.
Unscrew the Ignitor Cap located on the grill
Control Panel and remove the Contact and
Spring from the Ignitor Slot.
2.
Place the manufacturer
supplied AA battery
into the Ignitor Slot. Be sure to place the
positive pole facing toward you.
.
Place the Spring over the AA battery, then
place the Contact on top of the Spring.
Screw the Ignitor Cap back onto the grill
Control Panel.
Electrode Check - Requires an Assistant
Before placing the cooking components
into your
grill, ensure
that the Spark Electrode
Tip is
properly positioned
within each Gas Collector
Box
(a 3-1/4" wide stainless
mechanism
found at the
front between each set of burners.) The easiest way
to ensure this is to perform the following Electrode
Check:
1.
Be sure all Control
Knobs are set to OFF.
Open the Grill Lid.
.
Have an assistant
stand behind to the right
of the grill and look down at each Gas
Collector
Box. NEVER put your face inside
the Grill Head.
.
Press the Ignitor Cap and have the assistant
watch for a small blue spark within each
Gas Collector
Box. If a spark is present the
Electrode Tips are properly positioned.
4.
If no spark is seen the Spark Gap shown in
Fig. 13 needs to be adjusted
as follows:
•
Using an adjustable wrench, loosen the Inside
Nut just until the Gas Collector Box can be
maneuvered and turned upward.
•
The gap between the Spark Electrode Tip
and the Spark Receiver should be approxi-
mately 3/16".
•
If the gap is wider than 3/16" use a pair of long
nose pliers and gently squeeze the Gas Collec-
tor Box until the gap is correct.
•
Return the Gas Collector Box to its original
horizontal position, secure the Inside Nut and
try the Electrode Check again.
Figure
12
IGNITOR CAP
AABATTERY
SPRING
CONTACT
Figure
13 - Side View
GAS COLLECTOR
BOX
SPARK RECEIVER
IGNITOR SLOT
15
Advertisement
