Monitor Controls; Timer Controls - Arrakis Systems X-mixer-14-14 Technical Manual

CONTROL ROOM MONITOR & TIMER
The console has a full featured broadcast
monitoring system. It includes a control
room monitor, headphones, cue, talkback, &
uptimer system.
The control room monitor can select
between an external (usually off air) input,
Program bus, Audition bus, and Mono bus.
The monitor output has an individual level
control.
The headphones follow the monitor select
switch and have an individual level control.
There is no headphone jack in the console
chassis. The headphones have an audio out-
put which connects to an external audio
amplifier. The headphone jack is typically
embedded into the studio furniture.
The cue system features Autocue and a
separate "Assignable Output" that can be
setup as a cue output for an external amp
and speaker (or Record output for the Telco
system). Whenever a fader channel is placed
into cue, the monitor audio is dimmed by an
amount set in the PC setup utility, and the
cue audio is played over top. Autocue also
operates into the Headphones. If an external
cue amp and speaker are used then the
autocue feature can be defeated in the con-
sole setup.
Whenever a local microphone is turned
on, the console muting system is activated.
This results in the monitor and cue outputs
being muted to avoid feedback. A logic out-
Timer control
Timer control
Auto
: if the auto button is active
then the timer will be reset to 0
whenever an input channel (with its
reset setup on) is turned on.
Manual
: (Auto is off)
The front panel buttons will Start,
Stop, or Reset (to 0) the timer.
Phone section
these 3 buttons are
interlocked. They select the mix
minus feed to the caller when (1)
theTelco channel is On, and (2) the
Telco channel bus assigns are off.
Cue Volume
controls the level of
the cue output.
Autocue
no front panel control.
Setup by DIP switch or PC. When a
channel is placed into cue, the moni-
tor audio dims and Cue audio is
heard in the Monitor speakers.
T H E
Start Ext
Stop Pgm
Reset Aud
Auto Mono
TIMER
TALK
Pgm
BACK
Aud
Off
Line
PHONE
HEAD
PHONE
CUE
MONITOR
2 0
X - M I X E R D I G I T A L
put is also activated to drive an appropriate
On Air Warning light.
The timer features manual and automatic
control. When the Auto button is active on
the operator control panel, the timer is reset
to zero whenever certain console channels
are turned on. The channels that will reset
the timer are selected in the PC software
setup utility. The operator panel has switch-
es for manually starting, stopping, and reset-
ting the timer.
Operation of the control room monitor sys-
tem is displayed and explained below.
Control Room Monitor
Monitor Selector
(with headphone following) can
select an external (usually off-air)
feed, Program bus, Audition bus, or
the Mono bus
Talkback
push to send an audio
feed of the Control room mic plus
logic to an external studio for inter-
com purposes.
Headphone Volume
level of the headphone output. The
headphone output drives an external
headphone amplifier and headphone
jack. There is no headphone jack in
the console mainframe.
Monitor Volume
controls the level
of the monitor output.
C O N S O L E
the monitor
controls the