Table of Contents
Advertisement
12.
Prior to assembling sections (5) and (6), apply the mortar on interlocking portions of section
(3) and (4) and on the hearth itself as shown in the illustration below. Make sure to put the
mortar at the joint between sections (5) and (6).
13.
Apply the mortar at the interlocking joint of section (7), (6), and (5) as shown below. Be
sure to apply some mortar on the hearth prior to setting section (7).
14.
Do not skip this step. Apply mortar to all interior/exterior seams and smooth it out using
your finger, trowel or putty knife to ensure an air tight fit. Make sure that all gaps are
sealed with mortar.
15.
While the fireplace mortar is drying, attach the chimney following the instructions on page
14.
16.
After the chimney has been attached, allow mortar and cement to dry, following the
instructions on the label.
17.
Upon drying, cover the oven with the fiber insulation blanket provided in the kit. It is
important to wear gloves and masks when handling this material. Refer to illustration
above.
NEVER FIRE UP AN UN-INSULATED OVEN!
©Wildwood Ovens and BBQs LLC 2009
WWW.WILDWOODOVENS.COM
12
323.255.6587
All specifications subject to change without notice
Roma
Wood Fired Oven
Installation Instructions
Version 4.0
Advertisement
Table of Contents
