Figure 9-7 Menu 15.1.1.1: Editing/Configuring An Individual Rule In A Set; Table 9-4 Menu 15.1.1.1: Editing/Configuring An Individual Rule In A Set - ZyXEL Communications ZyWall 10 User Manual

ZyWALL 10~100 Series Internet Security Gateway
An IP End address must be numerically greater than its corresponding IP Start

Figure 9-7 Menu 15.1.1.1: Editing/Configuring an Individual Rule in a Set

The following table describes the fields in this screen.

Table 9-4 Menu 15.1.1.1: Editing/Configuring an Individual Rule in a Set

FIELD
Type Press [SPACE BAR] and then [ENTER] to select from a total of five
types. These are the mapping types discussed in the Web Configurator
User's Guide. Server allows you to specify multiple servers of different
types behind NAT to this computer. See section 9.4.3 for an example.
Local IP Only local IP fields are N/A for server; Global IP fields MUST be set for
Server.
Start Enter the starting local IP address (ILA).
End Enter the ending local IP address (ILA). If the rule is for all local IPs, then
put the Start IP as 0.0.0.0 and the End IP as 255.255.255.255. This field
is N/A for One-to-One and Server types.
Global IP
Start Enter the starting global IP address (IGA). If you have a dynamic IP, enter
0.0.0.0 as the Global IP Start. Note that Global IP Start can be set to
0.0.0.0 only if the types are Many-to-One or Server.
End Enter the ending global IP address (IGA). This field is N/A for One-to-
One, Many-to-One and Server types.
9-8
Menu 15.1.1.1 Address Mapping Rule
Type= One-to-One
Local IP:
Start=
End = N/A
Global IP:
Start=
End = N/A
Press ENTER to Confirm or ESC to Cancel:
DESCRIPTION
address.
EXAMPLE
One-to-One
0.0.0.0
N/A
0.0.0.0
N/A
NAT