Toshiba RAS-M10GKCVP-E Service Manual page 93

12-3. Outdoor Unit
No. Part name
Common
1
procedure
Front cabinet
2
Procedure
1. Detachment
1) Stop operation of the air conditioner, and
turn off the main switch of the breaker for air
conditioner.
2) Remove the valve cover.
(ST1TØ4 × 10L 1 pc.)
• After removing screw, remove the valve
cover pulling it downward.
3) Remove wiring cover (ST1TØ4 × 10L 2
pcs.), and then remove connecting cable.
4) Remove the upper cabinet.
(ST1TØ4 × 10L 2 pcs.)
• After removing screws, remove the upper
cabinet pulling it upward.
2. Attachment
1) Attach the upper cabinet.
(ST1TØ4 × 10L 2 pcs.)
• Hook the rear side of the upper cabinet to
claw of the rear cabinet, and then put it on
the front cabinet.
2) Perform cabling of connecting cable, and
attach the wiring cover.
(ST1TØ4 × 10L 2 pcs.)
3) Attach the valve cover.
(ST1TØ4 × 10L 1 pc.)
• Insert the upper part to the upper cabinet,
set hook claw of the valve cover to square
holes (at three positions) of the main unit,
and attach it pushing upward.
1. Detachment
1) Perform work of item 1 of
2) Remove screw (ST1TØ4 × 10L 1 pc.) of the
front cabinet and inverter cover and screws
(ST1TØ4 × 10L 3 pcs.) of the front cabinet
and lower part of the front cabinet and motor
base (ST1TØ4 × 10L 2 pcs.).
• The left side of the front is made to insert
to the rear cabinet, so remove it pulling
upward.
2. Attachment
1) Insert claw at the left side of the front into
the rear cabinet.
2) Hook the lower part at the right side of the
front to concave part of the bottom plate.
Insert claw of the rear cabinet into square
hole of the front cabinet.
3) Attach the removed screws to the original
positions.
1
.
– 93 –
Remarks
Upper cabinet
Upper cabinet
Claw
Square
hole
Concave part
Wiring
cover
Valve
cover