User Manual Introduction: Thank you for inviting BPA30 into your music life. The BPA30 is a portable battery powered amplifier. With the BPA30, you can easily perform your music outside with great tone, In order to achieve the most performance and safety operation, please read...
Page 2
1.) Features: Two input channels for connecting microphones (high and low Z) and instruments CD input jacks for connecting a CD or tape player, drum machine or other background source Headphones jack for monitoring Internal rechargeable power supply provides a minimum of 8 hours normal playing time ,the recharging time is no more than 6 hours Two-color power status LED: red indicates low battery, yellow indicates battery is okay...
2.) Front panel 1. Input 1 Volume: This jack accepts a microphone(high or low Z) or a instrument. 2. Input2 Volume: This jack accepts a microphone(high or low Z) or a instrument. 3. Equalization Low/Low Mid/High Mid/ High: These knobs are used to adjust the level in low/low mid/high mid/ high frequencies.
Page 4
3.) Rear panel DC Charger Plug: This jack accepts a 15VDC charger to recharge the battery (power switch off) or to supply power to the amplifier while playing (power switch on). DC CIGARETTE LIGHTER ADAPTER, 12 VDC: This jack accepts a small round connector of the optional 12-volt car adapter to power the amplifier from a vehicle instead of the internal battery.
Page 5
Application 1 Plug a mic into Input 1 and an instrument such as a guitar into Input 2. Any types of pickups are available. When any effect devices are needed, please connect the device and Insert jack , or between the microphone and Input1. Note that the effect is applied when the device is connected into the Insert jack.
Page 6
Application 4 Plug a mic into Input 1, and an instrument such as guitar into Input 2, and a drum machine, CD player or tape player into the Insert jack. The outputs of the CD/tape player must be summed to a mono signal with a 1/4” plug, as shown. 5.) Specification Output Power Rating 30W RMS @ 10% THD, 8 ohms,...
Page 7
86dB w/Gain switch in Channel 1 :9mV RMS Sensitivity Channel 2 :20mV RMS w/Gain switch out .7mV RMS w/Gain switch in Line In Insert .3V RMS Tone CHANNEL 1 +/–15dB @ 600Hz EQS CHANNEL 2 Low 12.5dB range @ 80Hz Mid 18dB range @ 850Hz High 13dB range @ 6kHz Tip Line In...
Page 8
Water and Moisture: Do not use this appliance near water (such as bathtub, washbowl, kitchen sink, laundry tub, wet basement, or near a swimming pool) Heat: Guard against the heat sources such as radiators ,stoves, or other equipments radiate heat. Power source: The appliance should only be supplied with the type described in the operating instruction or marked on the rear panel of the appliance.