Ap Info; Ssid - Cisco Aironet 600 Series User Manual

Chapter 2 Access Point GUI

AP Info

The AP Info tab (see
AP uptime, software version, CAPWAP status, and WAN gateway status.
This page also shows radio-specific information including status, frequency/channel, transmit power,
number of packets in and out, and number of bytes in and out.
The CAPWAP status shows the status of the AP's CAPWAP connection with the controller. The
CAPWAP status can be:
•
•
•
•
•
•
•
•
•
•
•
If the WAN connection is established and the AP's Gateway is reachable then the WAN status is shown
as Reachable, else it is shown as Not Reachable.

SSID

The SSID tab (see
configured security policy. Additionally, for Corporate SSIDs, split-tunnel status is also displayed.
OL-29882-03
Figure 2-1) shows the access point name, IP address, AP mode, AP MAC address,
Noop—Indicates CAPWAP is in No operation state
Init—Indicates CAPWAP is in initialization process state
Discovery—Indicates CAPWAP is in discovery state
DTLS Setup—Indicates DTLS connection is in progress
DTLS Teardown—Indicates DTLS connection is down
Join—Indicates CAPWAP is in Join state
Connected—Indicates AP and Controller is in Connected state
Image Data—Indicates CAPWAP connection has been established and is downloading the image
from controller
Configure - Indicates CAPWAP is in configuration state
Sulking—Indicates CAPWAP bad/stuck state
Idle—Indicates CAPWAP is in idle state without any operation
Figure 2-2) lists configured Local SSIDs and available Corporate SSIDs and the
Cisco Aironet 600 Series OfficeExtend Access Point User Guide
Home Page
2-3