Configuring Radio Channels On The Access Point; Chapter 3 Configuring The Acces Point - Cisco Aironet 600 Series User Manual

Configuring Radio Channels on the Access Point

Configuring Radio Channels on the Access Point
Follow these steps to configure a radio channel for your 600 Series OfficeExtend access point.
Step 1 Access the 600 Series OfficeExtend access point GUI as described in
page
Click the Configuration tab.
Step 2
The Configuration–System page is displayed.
Step 3 From the Radio Interface drop-down list, choose the desired radio interface, which can be either
2.4 GHz or 5 GHz.
From the Status drop-down list, choose Enabled to enable the wireless interface.
Step 4
From the Channel Selection drop-down list, choose the channel on which this interface will operate.
Step 5
Note
Click Apply to commit your changes.
Step 6
Cisco Aironet 600 Series OfficeExtend Access Point User Guide
3-2
2-1.
802.11n mode should be enabled by default. If it is disabled, choose Enabled from the
802.11 n-mode drop-down list.
Chapter 3 Configuring the Access Point
"Accessing the GUI" section on
OL-29882-03