Internal Settings; Jumper-Configured Options; Removing Top Cover - Benchmark DAC2 DX Instruction Manual

Internal Settings

Jumper-Configured Options

The following functions are jumper configured:
· XLR Output Pads
· Headphone Switches
· Headphone Gain
· Digital Pass-Through

Removing Top Cover

The DAC2 top cover must be removed to gain access to the jumpers. Do not attempt to remove
the faceplate or the rear panel.
CAUTION: The DAC2 contains static sensitive components. Static discharge may cause
component failures, may affect the long-term reliability, or may degrade the audio
performance. Use a static control wrist strap when changing jumper settings.
· Disconnect AC power by unplugging the power cord at the back of the DAC2 DX.
· Remove only the 8 screws holding the cover (4 on each side).
· Do not remove any screws on front or rear panels!
· Never remove the power entry safety cover in the rear corner of the DAC2 DX.
· Always connect a static-control wrist strap to the chassis before touching any internal
component.
DAC2 DX Instruction Manual Rev B Page 25