Table of Contents
Advertisement
Safety Information
Fuses
CAUTION: FOR CONTINUED FIRE HAZARD
PROTECTION ALWAYS REPLACE THE FUSES
WITH THE CORRECT SIZE AND TYPE (0.5A
®
250 V SLO-BLO
5 X 20 MM – LITTELFUSE®
HXP218.500 OR EQUIVALENT). THE FUSE
DRAWER INCLUDES TWO FUSES. ALWAYS
REPLACE BOTH FUSES AT THE SAME TIME.
Voltage Selection
THE DAC2 IS EQUIPPED WITH A UNIVERSAL
POWER SUPPLY. THERE IS NO VOLTAGE
SELECTION SWITCH. AC VOLTAGE RANGE IS
88-264 VAC, 50-60 HZ. THE PRODUCT MAY
ALSO BE OPERATED FROM DC POWER OVER
A VOLTAGE RANGE OF 125-373 VDC.
Power Cord
CAUTION: ALWAYS USE A GROUNDED
POWER CORD. THE PRODUCT IS EQUIPPED
WITH A STANDARD IEC POWER ENTRY
MODULE. USE AN IEC POWER CORD THAT IS
EQUIPPED WITH THE APPROPRIATE
CONNECTOR FOR YOUR LOCATION. CORDS
ARE AVAILABLE FROM YOUR DEALER.
DAC2 DX Instruction Manual
Modifications
CAUTION: DO NOT SUBSTITUTE PARTS OR
MAKE ANY MODIFICATIONS WITHOUT THE
WRITTEN APPROVAL OF BENCHMARK MEDIA
SYSTEMS, INC. MODIFICATION MAY CREATE
SAFETY HAZARDS AND WILL VOID THE
WARRANTY.
NOTICE: CHANGES OR MODIFICATIONS NOT
EXPRESSLY APPROVED BY BENCHMARK
MEDIA SYSTEMS COULD VOID THE USER'S
AUTHORITY TO OPERATE THE EQUIPMENT
UNDER FCC REGULATIONS.
Repairs
CAUTION: DO NOT SERVICE OR REPAIR
THIS PRODUCT UNLESS PROPERLY
QUALIFIED. ONLY A QUALIFIED TECHNICIAN
SHOULD PERFORM REPAIRS.
Rev B
Page 4
Advertisement
Table of Contents
