These operations are accessible by remote control.
Some may also be accessible by control panel on the main unit.
Initial setup
This section will guide you through the unit's initial setting which includes selecting
a language for your on-screen menu and auto tuning, which automatically scans
and memorizes viewable channels.
Before you begin:
Make sure the unit is connected to antenna or cable.
1
After making all the necessary connections, press . to Turn On the
unit.
• It may take a few moments to Turn On the unit for the first time.
• Initial setup menu appears automatically after the unit is Turned
On.
2
Use ▲▼ to select the on-screen language from the choices
(English / Español), then press OK.
Please select an OSD Language
English
Español
3
Use ▲▼ to select Air or Cable, and press
channels.
Tune Type
Cable
Air
• When Air is selected, the TV detects antenna signals. It searches
for NTSC channels available in your area.
• When Cable is selected, the TV detects signals supplied by cable.
It searches for NTSC and Cable channels available in your area.
• When the scanning and memorizing are completed, the lowest
memorized channel will be displayed.
• If you press
during the scanning, this operation will be
stopped and a confirmation display will appear, then you can
cancel scanning.
OK
to start tuning to setup
4 Use your TV
Switching on your TV and putting it in standby
mode
To Turn Power On or to Turn Standby On
•
Touch or press . on the control panel or the remote control.
Note
•
Energy consumption contributes to air and water pollution. When the AC power
cord is plugged in, your TV consumes energy. Your TV has very low standby power
consumption.
Adjusting volume
To increase or decrease volume
Touch VOL. ◄(down) / ►(up) on the control panel or
•
press VOL + / − on the remote control.
To mute or unmute sound
•
Press
on the remote control to mute the sound.
•
Press
again or VOL + / − to recover the original sound.
12
English