Table of Contents
Advertisement
These operations are accessible by remote control.
Some may also be accessible by the main unit's control panel.
Initial setup
This section will guide you through the unit's Initial setting which includes
selecting a language for your on-screen menu, country, location and
Autoprogram, which automatically scans and memorizes viewable
channels. You can also set the network connection in this setting.
B B efore you begin:
Make sure the unit is connected to an antenna or cable.
1
After making all the necessary connections, press
unit.
•
It may take a few moments to turn on the unit for the first time.
•
Initial setup menu appears automatically after the unit is turned on.
2
Use
to select the on-screen language, Voice guide, country, TV
placement and location in the middle of the TV screen, then press
OK.
•
You must set Home in location setting. Otherwise, Picture and
Sound settings you adjusted will not be memorized after the unit
goes into standby mode.
3
Use
to select Skip or Next on network setup screen.
4
Use
to select Wireless or Wired, then press OK.
Installation
This TV can be connected to
your home network.
Select your connection type.
1 234
Skip
If you have a wireless router, select Wireless to
Wireless
connect to the internet.
If you connect with an Ethernet cable, select Wired to
Wired
connect to the internet.
•
If you have a router with easy connect function, select Wireless and
use
to select Easy Connect, then press OK.
•
When you select On in the selection screen for Software update
notification, A message will appear later if there is the latest
software on the network server.
to turn on the
Wireless
Wired
56
7
5
Use
to select the signal type.
•
If the TV is connected to a cable or satellite set-top box, select the
2nd one and skip to step 7.
Installation
Select "Antenna" to set up a TV
signal from a cable TV wall jack
or a standard TV antenna.
Select "Set-top box" to set up a TV
signal from a cable TV box
or satellite TV receiver.
1 234
56
6
Use
to select Antenna for TV channels or Cable for CATV
channels, then press OK.
Installation
Make sure that you have
attached your antenna or cable
signal into the jack on the back of
your TV labeled "ANTENNA IN".
Now select either Antenna or
Cable, using up/down key of the
remote control. Once you have
made your selection, press the
OK button to proceed.
1 234
56
–When Antenna is selected, the TV detects antenna signals. It
searches for DTV and analog TV channels available in your area.
–When Cable is selected, the TV detects signals supplied by cable.
It searches for DTV, analog TV and cable channels available in
your area.
•
Auto programming will begin.
Installation
System searching. Please wait...
Auto programming may take more
than 20 minutes to complete.
Digital channels will take longer
than Analog to find and program.
Please wait until you see the Auto
Programming complete message.
1 234
56
Stop
17
.
English
Antenna
Set-top box
7
Antenna
Cable
Skip
7
Digital channels found:
0
Analog channels found:
0
Total progress:
7
Continued on next page.
Advertisement
Table of Contents
