NAD M17 Owner's Manual page 29

6 At "A/V Presets" page, set "Preset: 2" to the following conditions - use
[R/T] to select "Yes" or "No" and press [ENTER] to confirm selection and
move to the next setting.
While at "Save Current Setup to Preset" menu line, use [E] to save the
settings above to "Preset 2". When you recall "Preset 2" using the remote
control (for HTRM 2, "A/V PSET" + "2"), the above preset values allocated at
"Preset 2" (preset settings as shown in the OSD captures at Step 4) will be
recalled and implemented at the current source.
Note that "Speaker Setup" is set to "No". At this condition, there will be no
"Speaker Setup" values that will be implemented at "Preset 2". The "Speaker
Setup" settings that will be applied at "Preset 2" will be the last or current
"Speaker Setup" settings which in this sample are the same "Speaker Setup"
settings shown above in Step 1.
7 You can setup up to 5 A/V Presets. These same A/V Presets can also
be associated/defaulted to each Source in the "Source Setup (Normal
View)" window as below.
In the above example, "Preset 1" settings are allocated for Source 1.
Whenever Source 1 is accessed, the "Preset 1" settings will be applied to
Source 1. You can still manually override the assigned A/V Preset allocation
in a specific Source with another Preset setting/number by way of pressing
the appropriate remote control buttons.
RECALLING PRESETS
You may recall an A/V Preset number at any time using the HTRM 2 remote
control. Press the HTRM 2's A/V PSET key and then the numeric key 1-5
corresponding to the desired A/V Preset number. The newly recalled A/V
Preset will then manifest or replace the previous A/V Preset (if any).
OPERATION
USING THE M17 – SETUP MENU
29